B4/T4/SC10 FT Turnbucles / MIP CVD's
 

**EDIT** put B4 in title, but think these parts may be for the T4/SC10 only **EDIT**

MIP CVD's (fit SC10 & T4)

http://i31.photobucket.com/albums/c3.../sales/036.jpg

Cost me £26.99 and literally used once
Attached to losi hubs, so you get some new bearings, 2 roll pins, and blue spacer, and do what you like with the hubs?
Bearings aren't cheap over £6 a pair!! Wheel spacers £3.99
Well in excess of £40 - Asking £20 for the lot plus £2 posted first class recorded

I bought losi hubs in 1deg and 2 deg to add toe in to my SC10
One of these is fitted to the CVD's but unsure which at mo, but will throw in the other set free if someone wants to use these on their car.

It does mean reaming out your rear arms to accept the losi hinge pins.

For an extra fiver, i'll throw in a used once EDS 1/8" arm reamer (cost £8.99), and pair of 1/8" hinge pins to suit the hubs (pins bought were a tad too long so cut to suit length)

I literally fitted the cvd's to the hubs to obtain some extra toe in to my SC10 for one race, then picked up the Ghea toe in block, and went back to the standard hubs.

Hubs have losi crush tubes in them.


Factory Team turnbuckles with RPM yellow rod ends

http://i31.photobucket.com/albums/c3.../sales/038.jpg

Cost £29.99 for the turnbuckles, and a further £4.99 for the RPM rod ends
Sell for £23 plus £2 posted first class recorded
There is the turnbuckle wrench with this but forgot to photograph :blush: