Brushless and lipo's + related items!
 

Neu 1509/2y/s 1820kv motor - £30 requires sending off to neu to be repaired as the rotor just spins and there is no drive. Would make a great motor for any 1/8th buggy or smaller car.
http://i136.photobucket.com/albums/q...r/IMGP5003.jpg
HPI temperature gun - £15
http://i136.photobucket.com/albums/q...r/IMGP5007.jpg
Propeak sigma eq charger ac/dc and comes with the balance boards for all the different types of lipo connectors, it's in excellent condition hardly been used (boxed and with instructions)- http://www.tjdmodels.com/product.jsf?productId=2682
£50
http://i136.photobucket.com/albums/q...r/IMGP5006.jpg
http://i136.photobucket.com/albums/q...r/IMGP5005.jpg
ultrapower 15A power supply (boxed and with instructions) - £15
http://i136.photobucket.com/albums/q...r/IMGP5004.jpg



Now onto the motor
first up is a 9xl (1900kv) brushless motor with rc-monster clamping heatsink (will sell seprately if wanted) - £25
http://i136.photobucket.com/albums/q...ar/revo024.jpg

Spektrum Dx3 system with 1 receiver (has had a repair done to the aerial which has made it short) boxed in good condition - £70 posted
http://i136.photobucket.com/albums/q...r/IMGP4776.jpg
http://i136.photobucket.com/albums/q...r/IMGP4777.jpg
http://i136.photobucket.com/albums/q...r/IMGP4778.jpg
http://i136.photobucket.com/albums/q...r/IMGP4781.jpg

Mod 1 pinions ( 12, 13X2, 15, 16, 18) £5 each

2 X Zippy-R 4500mah 21/30C 14.8v/4s lipos perfect for 1/8th scale setups. in good condition approximately 30 runs in total and matched to each other so you can use them in parallel for a whopping 9000mah single battery. an extra layer of clear heatshrink has been added for extra protection and one of the batteries has a small tear in the white heatshrink below this but this doesn't effect how it runs - £40 for the pair
http://i136.photobucket.com/albums/q...r/IMGP4087.jpg
http://i136.photobucket.com/albums/q...r/IMGP4088.jpg
2 X FTX 5000mah 20C 7.4V lipos again perfectly matched to each other so they can be used in series for 14.8V of voltage - £40 for the pair
(the heatshrink on the wire has cut near the exit of the wires from the hardcase but this has been taped and i can heatshrink before i send it out if you want. there are scratches on them but none are serious)
http://i136.photobucket.com/albums/q...r/IMGP4090.jpg
http://i136.photobucket.com/albums/q...r/IMGP4091.jpg

Both + postage

Dimensions of the batteries:
Zippy R's - 200X45X20 each (LXWXH)
FTX 5k's - 135X45X22 each