Diff problems
 

Hi
Ran my car yesterday but the diff does not feel tight slips under acceleration loosen the slipper but then not enough drive out of corners or out on the straight.Never had a problem like this before
Is this a problem car is a new batch version,have had a losi and a b4 no problems but this ????

thanks

Does the C clip spin easily inside the diff as that needs to be tight. A few of us also glue the plates to the diff halves so that it doesn't slip there etc.

Slipping diff
 

Hi mate...This sounds a pretty obvious question... but have you checked that the grommet setting screw inside your diff outdrive is very very tight? It needs to be super tight for diff tolerance to be held in position.

Hope the grommet tip helps...basic answer but so easily missed mate.

Good luck :thumbsup:

if the diff is loose tighten it up till it doesn't slip, if you cant do this without put to much strain on the screw its has been built wrong,

All sorted replaced the washers and the clip tight now