using JC wheels on the cat
 

Since I moved from the B44 I had a load of wheels remaining. Is there any problem running these on the cat? thinking about a possible difference in offset or something...

it fits in the box with room to spare at the moment.

The only problem is with the kits front hex adapters, they are too thin and leave the wheels rub the hubs. Intsall the associated adapter... they are thicker by 1mm and provide the nessasary clearance.

Doesn't that then change the track width etc.

yeah I found that out straight away lol. installed B44 ones and no problems.

all the wheels I supplied you were b44 ones, the hexes from schuey are fine, you just run them on the ouside of the pins, simples.

I did that, but found because the purple hex was slightly tappered on the 1 side it started to turn in the hex of the wheel. The b44 hex solved this.

The ones you gave me wes I have 10 more sets from when I ran the B44 so it's all I have apart from the couple of revlite ones I got last week from you