missing a hole?
 

hi, ok went to change to the outer holes on the front wishbones only to find there is only one hole there even though there is 2 on the setupsheet?
there is a half hole there but doesnt look right. Is this a manufacturing fault or should i force the screw in to open it to a full hole? :wtf:
ta
dan

Ermmmmmmmmmmmmmmm:wtf:

Take photos of them if you could and PM them to me....
If there is no way of getting a screw into the half hole, please take them back to the model shop you got them from and get replacements. They should then send them to Mirage and get replacements back on their shelves....

If not, send them to Mirage direct and buy some spare in the meantime.... Spare wishbones are always useful....

I've not seen or heard of this problem....:confused:

ok cheers, thought it looked a little strange. will try the screw anyway see what happens

thanks

just to clear up, wishbones are not faulty, just stretched my hole a bit too much ;)

cheers adam

Ouch..... :rolleyes:

You should really see a doctor about that!!:D