X6 motor fitting
 

After building my new Ellis Stafford edition X6 I am going to fit the electrics but the motor screws from the B4 look a bit short.The X6 motor plate is twice as thick as the B4 so there isn't much thread to go into the motor.Is this OK or are there any longer ones available.

Hi,
I say minimum 4mm you need to enter with the M3 bolt in the motor. If not, you can easily overtight the tread in the motor...be careful.

I use these http://www.jespares.com/electric-mod...rd=motor+screw
from JE Spares