Neewb,charging woes.
 

Hello everyone.
I'm very new to RC and have recently acquired a
Competition Electronics Pitbull X3 charger.

I have three batteries.
1 NiCd 1900 mAh
1 NiMH 3700 mAh
1 NiMH 4300 mAh.

What charge rates should i be using and how long should it take to charge ?
Will the charger stop charging automatically ?
Should i be using single rate or triple rate charging ?
What difference will it make ?

I will apologise now for my supreme dumbness.
Sorry !
Any help will be most graciously received. :blush:

Golden rule: charging rate = 1C

so for the 1900mAh pack = 1.9 Amps
" " " 3700mAh pack= 3.7 Amps
" " " 4300mAh pack = 4.3 Amps

With regards to the charger 'modes' I would say discharge the NiMH packs, equalize, then charge once. If setup correctly, the charger should cut out properly, so I would read the manual before starting off.

HTH

Mark

oh then my battery will be dead prettty quick hah 5 amps on a 3600 awsome!!!:thumbsup:

Thanks Mark.
I shall give it a go.:D

remember one of your packs is nicad so charge it on the nicad setting and the nimh packs on the nimh setting.

A

I've had a good look through the setting and I can't find a Nicad setting.
:cry:

Heylp.:D

The nicd must be well old!
Throw it in the bin...:thumbsup:

Ok fair comment Col,
Who needs a wanky old Nicad anyway.:blush:

I used to run 3700mah cells and always charged at 5A as recommended by manufacturer (Novak). never had any problems. From what I remember About 45 mins charge time from discharged.