Tekin RS transmitter setup...
 

I have an RS in my B4 but last time out it had apalling brakes. In my previous car it was doing endo's but I think it must be a calibration/setup problem. I am running an ex10 steerwheel (ko esprit uses similiar menus I think).

I find the instructions on setup a little confusing from Tekin with regard to the timings when following the lights. Can anyone explain the process they use with their RS and any adjustments they made...

Thanks
Mark

What exactly do you need to know? The setup should be done, as such

EPA on throttle and brakes should be at 100%

Turn on ESC
Hold the buttons down, to go into setup
Middle LED should flash (with beeping), trigger should be at neutral, you will get a warble when neutral is set.
Top LED should flash (with beeping), pull trigger to full throttle, you will get a warble, full throttle is set
Bottom LED should flash (with beeping), push brakes full on, you will get a warble, full brake is set.

If you don't get a warble on full throttle, try reversing the throttle channel on your radio, or increasing the EPA on throttle and brake to 120%, then 150%

Hope this helps a little.

Thanks DCM, I will try your suggestions, as I think I might have had problems with the brake position being fully being reached.

Will try this tonight, and report back.

Thanks,

no worries, some transmitters just are a little out compared to others.