help please
 

ive got a ezrun speedo ste up in one of my cars but i need to set the speedo up to the transmitter but ive no instruction
the speedo is set up right through the card thingy so i know thats ok any of you guys got any instructions /help cheers:thumbsup:

A) Switch off the ESC, turn on the
transmitter, set the direction of throttle
channel to ”REV”, set the “EPA/ATV”
value of throttle channel to “100%”, and
disable the ABS function of your
transmitter.
B) Hold the “SET” key and then switch on
the ESC, and release the “SET” key as
soon as possible when the red LED
begins to flash.

C) Set the 3 points

1) The neutral point
Move the throttle stick at the neutral
point, and then click the SET key, the
green LED flashes 1 time.
2) The end point of forward
direction
Move the throttle stick at the end
point of forward ----> direction (reverse/brake) , and then
click the SET key, the green LED
flashes 2 times.
3) The end point of backward
direction
Move the throttle stick at the end
point of backward <---- direction (throttle), and then
click the SET key, the green LED
flashes 3 times.
D) Throttle range is calibrated; motor
can be started after 3 seconds.

great thaTS worked a treat thanks mate

this any good to you?

Click for Manual