Seized bearing stuck in motor...
 

Does anyone have any idea of how to get the outer ring of a bearing out of a motor?

warm up your soldering iron hold it on the alloy can outside the bearing,when the alloy its red hot tap it out from the other side

yes, similar thing I would suggest, although if you got a butane torch, might be a bit better.

Would that not melt the alloy? :confused:

I wouldn't of thought so... I had a similar problem with a part on a DH bike... The part was some awful soft rubbish, and that didn't melt.

Got it out now thanks for the tip Carl & DCM soldering iron did the job lurvly :thumbsup: Now where to get replacement bearings for it....

same trick will work well for fitting the new bearing to save bashing it in, bearing in freezer for 15 mins, can wamed up they should just push together