t peice
 

any news on the T peice if so I might give one a go !:thumbsup:

from what i have gathered on here the new t's are thicker ;)

you should of got a steel 1 of paul when he had them he had loads ask him to give you the shops he sold them to denmark i think

Denmark :D? Im from Denmark. Ive only seen one shop that sells madrats

i had a link for them pm paul he mite send you it

AnswerRC now stock the alloy T pieces so I believe

i have been told these are rubbish as they bend so badly

the new plastic one is good though its strong i have not broke a new one yet

pm paul ask him which shop he sold all is to i know it was in denmark

Been told they are rubbish? An alloy one would be, thats why we dont have one and never made one!

Watch this space though for some upgraded ones which are better than alloy.....

alloys bit for the madrat cant wait

x pro
 

iv'e just got an x pro and it's FAB!!

can't imagine why you would want a steel t piece though??:confused:
i found i needed more wieght in the front 1/4 of the car so i got the carbon fibre t piece and the new brass bulkhead (which i must say is an amazing idea with the weight you can put in and out from track to track)

also i put 20grams in both front pods to generate more side bite/roll through a corner.

they just snap for fun i had a carbon 1 that snaped and the steel 1 are ace and get rear pin holders under the tplat they all snap the plastic not that strong
and get a brass battery tray £19,99
rear pin holder £17.48alloy under the tplate

ent snapped a t yet, must not be driving it hard enuff :blush:

i had 2 tplate plastic if it does not land right they just snaps and a carbon than just snaped for fun as well. hit the power and you will see dan

don't get a brass battery tray if you have a madrat, as it won't fit with a 23mm deep lipo. you cannot get the battery strap on. Not sure if the X pro has adjustable height battery posts or not, in which case it would be ok, but for the madrat it is no good unless you have VERY thin lipos.

i seen a smart brass plate for on top of the servo made by trish bits i think

40grams if i remember right £7.99 any one got one of these ? 40 grams make much affect guys ?

i would just buy a pack of adhesive lead weights, you can get 200g for the same money

true, is a bit posh tho ay

cheers bud

Contact answer rc pete or jmsjms for stainless t's

The steel t is a must if you drive it hard. Its only 45g in total.