oOple.com Forums

oOple.com Forums (http://www.oople.com/forums/index.php)
-   1/8th ELECTRIC Off Road (http://www.oople.com/forums/forumdisplay.php?f=74)
-   -   Castle Mamba Monster ESC problem (http://www.oople.com/forums/showthread.php?t=32333)

hockeyhead019 16-10-2009 10:24 PM

Castle Mamba Monster ESC problem
 
hey guys

ok so i finally got everything set and was ready to calibrate my esc like it says to... connected the batteries and held the trigger down and hit the switch... nothing happened :( i have power because i have steering but the esc won't make any noises or light up or anything... any help would be greatly appreciated... thanks

-Jim

stampede vxlboy 17-10-2009 07:44 AM

turn the wires the right way i got a mamba castle i can set it to any control have you put the wires wrong way around servo i can set it to any control but if there just turn the front wheels turn the little black tab around and it should work if not use you pc to set :thumbsup:
turn it on but hit the red switch at the same time as turning it on . if not the lights will just flash .?
pull the handset back turn it on at the same time press the red button and lift off

Marvin 17-10-2009 08:10 AM

Quote:

Originally Posted by hockeyhead019 (Post 299155)
hey guys

ok so i finally got everything set and was ready to calibrate my esc like it says to... connected the batteries and held the trigger down and hit the switch... nothing happened :( i have power because i have steering but the esc won't make any noises or light up or anything... any help would be greatly appreciated... thanks

-Jim

Definately wired up the correct way round? Is your throttle on your radio reversed? If it is (except on Futaba) then it needs to be the 'normal' way round. Make sure your throttle trim is neutral too.

If that all fails, then it looks like it'll have to go back to Castle Creations. Send them an email to see if they come up with anything.

hockeyhead019 17-10-2009 11:41 AM

if my wiring was backwards y do i still have power to the steering servo? i would think that if i was backwards then the power wouldn't work... so i'm inclined to think that i have it wired correctly as it matches the orientation of my steering servo... however i missed the part about having your controller reversed so i'll check that out... thanks guys

Marvin 19-10-2009 07:26 AM

Oh, must have missed the bit about the steering servo still working. Try the radio re-calibration, and if that fails, get onto Castle Creations, it may need to go back. Don't worry though, they have excellent service.

hockeyhead019 19-10-2009 11:56 PM

thats exactly where i went... castle's help was great... apparently i had a bad controller :( it happens though and their going to ship me a new one tomorrow and all i have to do is send the defective on back to them

castle's customer service gets two thumbs up and more if i had them haha


All times are GMT. The time now is 09:15 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com