question about the clutch bell on my car...
 

Ive just bought a Hyper 7 .21 engine for my hong nor x1cr to replace the broken force .32 engine i had. I used the fly wheel and clutch bell off my old engine on my new 1.

When the clutch bell is I cant screw the retaining screw all the way in the end to hold it in place because it locks up the bell because its tight against the bearing, if i dont fasten it all the way in the bell does move but it starts to work its way off and the bell itself starts to come off, is there any way of getting round this? can i get a shorter clutch bell?

Hope that makes sence

You need a set of these:
http://www.cmldistribution.co.uk/cml...tId=0000001515

The black washers next to the screws at the top of the picture are like top-hat spacers, and effectively make the crankshaft longer, so the screw does not pinch the bearings.

Hi Mate,

How many shims have you put behind the fly wheel? If none then you'll need to get some shims that fit inside the clutch bearings inner race, and space it out until you have got 0.3 -0.7mm end float.

Tim

Or one of these ;-)

The bit in the bottom left that looks like a top hat.
Give us your address and Il drop one in the post as a freebie or drop it off as you cant be far from us.

ANSCS4002
http://answer-rcusa.com/zencart/images/ANSCS4002.jpg

Can't argue with that!

Aw thanks very much mate, ill pm it to you now
Cheers

Can i have some then please:thumbsup: