Ball Joint Part Numbers
 

For those of you who are running RPM or Losi ball cups on your DB01/TRF501/511, can you tell me what make you are running with the part numbers too if you've got them please?

My balls are worn :woot: and as I have loads of RPM/Losi ball cups I thought it would be better to just replace the balls to suit.
Thanks!!

I can't help with part numbers but I was running Hot Bodies D4 balls on my 501X

I use:
LO-A-6015 (Losi white ball cups)
HB-61582 and HB-61581 (Hot Bodies ball studs)

Found them at rcmodel.com.hk

Thanks Jimmy & Fredrik, just what I'm after.
How do they compare pricewise to others?

I use the Hot Bodies studs and JConcepts cups on my 501. Just bought a set for my db-01 this week and it was £6.50 for each pack of balls (8 in a pack) and about £7 for a full set of cups. Only thing I found is that the tamiya cups have a lot longer arm than the Jc ones so theres not as much thread in the cup so its not quite as strong but I haven't had one let go yet so it can't be that bad.

Thanks, not bad then.
I already have the RPM and Losi cups, but realised last night that they don't fit the tamiya balls, it's good to know that they fit the HPI balls well.

Who mentioned HPI balls? Hot bodies i think you mean;)

oops, freudian slip there!

Do the ball cups fit the standard 3mm thread turnbuckles?

i've put schumacher ball joint on with rpm ball cups

I found mine at racingfactory.

Ball studs :
http://www.racingfactory.fi/products...-x-10mm-101702

http://www.racingfactory.fi/products...-x-13mm-101837

Ball Cups :

http://www.racingfactory.fi/products...ural-16-101716

Service is excellent... I always email Kenneth to ask the stock situation...


They are a perfect fit... I also use them on the entire steering rack and have almost zero tolerance for 2 months now... :)

Regards.

Thanks for the replies, have ordered some Schumacher ball studs now as they were very cheap:D