oOple.com Forums

oOple.com Forums (http://www.oople.com/forums/index.php)
-   X-Factory (http://www.oople.com/forums/forumdisplay.php?f=16)
-   -   possible to convert x6^2 to x-60 (http://www.oople.com/forums/showthread.php?t=29130)

fastinfastout 19-08-2009 10:56 PM

possible to convert x6^2 to x-60
 
I have a squared, and was wondering if it could be converted into an x-60.

peetbee 19-08-2009 11:00 PM

I can't see any reason why not, you can convert a B4 into a T4 easily enough. It's just a new chassis, shell, rear wishbones and possibly rear shock tower. Then you'd have to get hold of all the T4 parts too.

Nehpets 20-08-2009 12:15 AM

Don't see why not...

Off the T4 you'll need:
Front shocks and springs,
Front arms,
Front shocktower and body mounts,
Driveshafts,
and Turnbuckles all round.

Off the X60 you'll need:
Rear shocktower and body mounts,
Rear arms,
Chassis,
and the X60 body.

Could be more parts that I've forgotten as well.

Good Luck.

YoungChazz 20-08-2009 04:14 PM

Will also need rear shocks & springs. Truck shocks longer.

Body Paint 21-08-2009 08:22 AM

You could use the rear shocks/springs off the X-6 on the front of the X-60

super__dan 21-08-2009 09:55 AM

In my opinion there are so many things to change that it's usually cheaper (and doesn't stop you using the X6) to buy a used T4 and then just get the conversion. As otherwise you end up with a loads of bits that can't be used and only 1 car/truck. Where as the otherway you still have 2.

YoungChazz 21-08-2009 02:57 PM

Dan has always been the practical one. I think he's right -- no more expensive and probably faster to get a (possibly used) T4 and an X - 60 Kit. Plus you wind up with two great cars. Mo' betta.


All times are GMT. The time now is 04:34 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com