remove one-way bearings
 

hello

is there anybody who knows how to (switch) remove the one-way bearings, because the difference in diameter on the axle (left-right) and the white 36 diff gear

i want then centric on the axle, but i must switch the bearings then and i don't know how to do this:rolleyes:

grtz
dave

they are a press fit, the only way your going to get them out, is by warming the one-way axle a little and then gently tapping out the bearing.

i tryed that, but with no luck:(
still can't get them out
any other sugestions:confused:

grtz
dave

nope, as it sounds like it is bonded in, unless you can press the bearing out.

BTW here's a pic from my nice painted body:)
http://users.telenet.be/xinon/tamiya%20008.jpg

grtz
dave

Why do you need to run a TA05 pulley on the front? If it's to get rid of the overdrive, your best bet is to put what was the front diff (with the black pulley) in the back, and re-gear it slightly on the spur and pinion, probably up 1 or 2 teeth. You're better not mucking around with the 1 way if the bearings are pressed or bonded in, you'll likely break them trying to get them out. :o
-Steve

does the diff have steel out drives

As far as I know the front and rear diffs in the 501 kit are identical apart from the pulley. I might be wrong though. ;)
-Steve

your right there Steve the diffs are the same front to back.