Hobao Hyper 9E
 

I'm selling my Electric Hyper 9 (not converted, it's the official, factory 'conversion'). It has been used at two race meetings from new. I'm selling with all the electrics, bar the transponder, radio gear etc. This is my spare car, that, as 1/8 brushless is so reliable, I don't need.

Specifications:

• Hobao Hyper 9E (2 race meetings)
• 3x Flightpower Evo 25 4350mAh 4S Lipos (3 meetings worth of cycles, I would estimate 6-8 cycles each)
• Castle Creations Mamba Monster Max (3 meetings use)
• Medusa 36-60-2000 Motor (3 meetings use)(2000kV)
• Futaba BLS-451 Servo (3 meetings use)
• Spare Front right arm (have used the left one - I'm not that great a driver!)
• Spare Shock plastic parts - 3 unopened packs, 1 opened
• Alternative Wing mount (to use normal wings) (unopened)
• Front and rear anti-roll bar sets (unopened)
• Alternative ackerman wires (unopened)

The Hyper 9E has not yet been released in the UK, and I believe this is the only one in private ownership in the UK.

I would prefer not to split, but will give it a couple of days, and if no interest is there for the whole lot, then I will split. PM me interest regardless whether or not I've announced that I'm splitting.

PM me sensible offers. The RRP for this lot is over £1000 (worringly...) (assuming the 9E will cost the same as the nitro 9 when it is released).


Piccies up tomorrow!

A couple of piccies from after the initial install:

http://lh6.ggpht.com/_pJNeulUYR5E/Se...0/DSCF0011.JPG
http://lh6.ggpht.com/_pJNeulUYR5E/Se...0/DSCF0008.JPG
http://lh4.ggpht.com/_pJNeulUYR5E/Se...0/DSCF0006.JPG

Hello mate!

I was the one in the shop the other day yacking to rich about my H9 nitro, and a dodgily sealed Hyper 7 Black engine.

Do you have any spares that you are getting rid of also? or are these included with the car

Cheers

Steve

They're going with the car, sorry...

Piccies!

http://lh3.ggpht.com/_pJNeulUYR5E/Si...0/DSCF0001.JPG
http://lh5.ggpht.com/_pJNeulUYR5E/Si...0/DSCF0001.JPG
http://lh6.ggpht.com/_pJNeulUYR5E/Si...0/DSCF0002.JPG
http://lh4.ggpht.com/_pJNeulUYR5E/Si...0/DSCF0003.JPG
http://lh5.ggpht.com/_pJNeulUYR5E/Si...0/DSCF0005.JPG
http://lh4.ggpht.com/_pJNeulUYR5E/Si...0/DSCF0007.JPG
http://lh6.ggpht.com/_pJNeulUYR5E/Si...0/DSCF0005.JPG
http://lh6.ggpht.com/_pJNeulUYR5E/Si...0/DSCF0004.JPG
http://lh3.ggpht.com/_pJNeulUYR5E/Si...0/DSCF0006.JPG

There we go!

Just pretend the PTx isn't there!

I haven't pictured the Anti-roll bar sets, the alternative wing mount, or the Ackerman wires, as I didn't have them on me when I took the photos.

Hi Simon am interested in cells

Hi Ade

Will let you have first dibs on them if/when I split.

Hello, will take the MMM for the right price of you end up splitting

I'll announce when/if I'm splitting, and you can have 1st dibs on the MMM.

Whole lot SOLD/SWAPPED