pistons help
 

Hi Guys

On the x6 when running AE shock I’ve read a few post by the team drivers that fitting losi pistons is advised

What losi pistons are the equivalent to AE- do the pistons need filing to fit?

any one

Not too sure on ther comparison off the top of my head (although there ae some good spring and piston comparison charts around) although I can say that it is the red pistons we tend to use in the X6 and they drop straight in with no alterations...

now your all back from racing in Oz

any one able to help

Darren said they will fit

but id like to know what the losi / ae comparison is

I'm sure there are dozens of answers to be found, if not here then on other forums.

I don't think there's a 1-to-1 comparison, IMHO, a piston always feels different from one with 3 holes. If you get the static damping the same, the pack will be different, and vice versa.

But as *very rough* guide, #1 = 55, #2=56, and #3 = 57.


Why do you need the conversion anyways? 90% Of the X-6 set-ups you'll find will use Losi pistons.

Yes they fit straight in, red is similar to #2, I think , there was a post in the general section a week or so ago with a full comparison chart.

Post a Q in the J Concepts thread as Rich Lowe will know.

They wont be exactly the same mind, remember that the AE piston has square edges and the Losi piston has rounded edges, even the material used can make a little difference to how the oil flows round them.

Edit: beaten to it by the Elvo meister

ok so a blue losi would be close to an AE 05 if there was one

Close to an AE #0, which doesn't exist, and would probably be very hard to make; I'm quite sure the E-clip would block part of the hole and disrupt the flow.

Ill just stick to my AE 0s i have then

ta for the replys

I'ven't seen this one!!
You'll find your answser here even it too late as some answered.