looking for a straight swap.
 

right i have a tenth tech predator P8 including ball raced rockers n steering. theres a good lot of spares including spare chassis with cell slots cut out spare bearings for the entire transmission, a tub of diff balls and same amount of thrust race balls and washers ect, roughly 4 pairs of complete diffs as well as 3 complete modded Tc3 diffs and 2 tc3 pinions (only needs the addapters) theres 4 pairs of crown gears and about 6 pinions. theres also lots of drive shafts, hubs, and wishbones plus a spare front top diff housing. also included would be a nosram dominator evo speedo, standard hotwired accoms servo, 2 or 3 motors (various makes and all 10x2) a pack of Gp 3300s, an lrp diamond tipped comm lathe and anything else iv forgotten! pic of pred in profile.

what id like is a similar setup but in 1/8th nitro rally x with starter, engine, pipe, throttle servo, maybe some spares n whatever else you wanna chuck in!
cheers
\Ro

ggivimg up EP then?

not sure it depends whats offered really:eh?:

change of plan! my new main club will be electric n runs in falkirk! i was gonna give it a go over at csor but your alegedly not allowed to have an opinion over there or stick up for yoursely:yawn: shame theyll have "the best track in scotland" but itll be run by monkeys:p