Transponder Port on Receiver
 

Hi All,

Can someone remind me which port on the receiver the transponder is normally plugged into?

Thanks!

A spare one :)

Ch3 usually

Thanks Tony!:thumbsup:

Any providing its not steering and throttle channel, all the plus and minus pins are on the same track in the circuit board. Only signal wire varies. I all ways use the B (battery) port.

If using the Core Code system ch3 can be switched off on the TX, seen that a lot

The transponders are normally plugged into the battery port on the receiver.

Correct as can ko, but it does not disable the positive and negative which powers the pt, they are as I put above all on the same tracks on the circuit board

Thanks all!:thumbsup: