B6 Setup - Kidderminster May 2017
 

Here's my B6 setup from Kidderminster in th dry today.

Front:
37.5 weight oil
2x 1.6 pistons
Orange Spring
Short shock end
Middle hole on gull wing tower
Middle hole on gull wing arm
Plastic arms
Alloy bulkhead
0.5mm shim under chassis/above bulkhead
21mm ride height
5 deg caster
25deg kickup
1mm from bottom axle height
STD Ackerman
1 deg camber
Middle on camber link, 1mm washer inside
Inner on hub for camber link

Rear:
30wt oil
2x 1.7mm piston
Grey spring
21mm ride height
Middle hole on tower
Inner on arm (plastic)
Kit anti squat and toe in
0mm axle height on hubs, (pin at top)
Medium wheelbase
Shocks on front of arm
1.5 deg camber

Middle, 2mm washer under ball stud on inside
Middle on hub, upper position

Others
Steel ESC and Servo weight
Alloy bulkhead
No weight under 4100 full height lipo
HW 3.1 speedo
Full size hi-tec servo
Reedy M2 7.5 motor - 21/78

Sch yellow cut stagger (no foam) narrow wheel
Sch yellow darts, blue medium foam, std wheel.

Anything else just ask.. :-)

How long were you getting out of the darts Mark ?

Well I had two pairs of rears.
One scrubbed set, one new. Whilst they were visibly worn, I reckon I could use them for another meeting with ease.
Minispikes would have one set nearly bald from last year, so a big improvement in my opinion!

Without any tarmac, I reckon two meetings easily.