yz10 race buggy
 

finally sorted a yz10 for the track came off a ex national driver so far light strip and clean also added b44ft shocks and new body and less warn front drive shafts , is not to clean but is super free running and diffs very nice. Hopefully get electrics in this week starting off with 10.5t will run it fixed spur to start with have a tcs to fit if needed :)
http://i1295.photobucket.com/albums/...psutcbxrol.jpg
http://i1295.photobucket.com/albums/...psboydkmjb.jpg

nice hifi

:lol: car looks good too which version is it?

Nice looking racer yz-10!:thumbsup:
I like the lrp y-spoke wheels, i have some sets too!

It seems like a mix of different versions, the chassis is from the '94, the shock towers and the rear link mount looks like from the '95, the top deck and steering links are aftermarket one, i guess!?

My runner will be a mix version too, but still looking for some bits and time, to finish it.:)

Would be interrested in, what length of shocks you did use on this yz-10, or do you have part numbers?

94

Everyone's loving the boom box :lol:

There Phoenix bell cranks and the towers and topdeck are Fiberlitye

Thanks still need few small bit doing but is just about there. i bought the shocks of ebay were told they came off team associated B44
not sure of part numbers. length front top screw to bottom screw 76mm extended 58mm compressed rear 85mm extended 66mm compressed

thanks mr Peak you is a mind of knowledge when it comes to yokomo's and vintage rc :-)

Thanks for the info about the b44 shocks, i much appreciate that!

If you are in the need of a center layshaft to mount modern spur gears (Kimbrough,...), i have like five sets of them!?

Sorry for the bad quality and i only can post 1 picture with the ipad.

Here is another one were i dont know the parts #, but it looks new, just repacked!