RC10B6
 

Hi
Thinking of an RC10 B6
If I bought the Team kit are there any option parts people consider to be a 'must'?
Thanks

So far I've bought the brass bulkhead and ESC weight...

https://www.dms-racing.com/index.php...ategory_id=576

https://www.dms-racing.com/index.php...ategory_id=576

Get my B6 & build going well.
Struggling with ally servo horn.
One I had previously was to talk so fouling, been & got another & also to tall.
Which one do I need to buy?

Thanks.

The AE one for the car

Servo horn
 

AS1366 That's 25 tooth
AS1364 That's 23 tooth

So just depends on what servo you have you can get them from mb models

Alternatively I've successfully used the hudy v2 offset horn when I had mine.
DY293493 25t
DY293492 24t
DY293491 23t
Availability on these is usually better...

I can't understand why so many people have clearance issues with the ae horns, plastic or alloy. If the servo is spaced correctly, I.e. 90 degree drag link, there should be plenty of clearance. Maybe you've fallen for the trap of using too long screws to attach the servo to the mounts causing contact with the side rails. This would be pretty obvious though as the servo wouldn't sit flat. Some low profile servos have a spline location some 4mm closer to the edge, these aren't suitable for the b6.

Hi
The problem was the OE horns didn't fit the servo so they were out of the question.
The ally horn I have was slightly to tall. Two hole options & top unused hole fouled.
Before I buy another I wanted to see what others used.
Ordered an Associated one now.
Cheers