Esc switches off after a few seconds of brake?
 

I have a skyrc toro 120a esc which I accidentally connected up the wrong way round... it now seems to work ok going forwards, but shuts down after a couple of seconds on the brake.

Is it goosed?

some speedos have an "auto" switch off function after holding brake for a few seconds

I have a HW with this function its possible you may not have noticed this function before


im not sure if you can switch off this function or not

regards dave

update firmware. I can help with this..
Alternatively set break endpoint to less than full so it will never be able to switch off, as it can't hit full break endpoint for the required time .

Thank you chaps for taking the time to reply.
Tim