Yokomo YZ-10
 

Hi guys i recently picked up a yz10 and a bosscat. Im in the process of rebuilding the yz10, and the front lower bulkhead has broken, that holds the shock tower on. Looking for a replacement new or used. I got a tub full of spares too, but that's the only bit i don't have. Lol. Also i was told it was a 94, but if you guys could confirm this as im not 100% because i think the top deck is fibrelyte and i have several different types of shock towers. Any help is much appreciated. (Photos should be attached)

Cheers Mitch

Welcome Mitch I've already seen this and yes it is a 94 with carbon towers and top deck which is either Fiberlitye or CML. Looks like a good base with the all important TCS and what looks like works 93 turnbuckles 😉

My advice would be to strip it and give it a good clean it should clean up well, then see what it needs. I should have a spare bulkhead I'll check and see what I have. Looks like you need a rear tower too but like I said see what else it needs if anything.

Cheers Peaky, yes i am going to strip it this week and see if it needs anything else, there are a few little things but Stu said he might be able to sort me out with a few bits im missing.

Will keep posting updates,

Cheers Mitch

any ideas on the part number for the bulkhead?

No sorry bud, think ive found the right manual online but it doesn't show any parts numbers.

There's a manual here but as for part numbers there not great

http://www.competitionx.com/pdf/vehi...-10-manual.pdf

I'm not expert you see I have some new in packet bulkhead but I've no idea if they are for your car

I can help with yz10 94´ parts number, I have some old japanese Yokomo catalogues, if needed by someone.

We are after the lower front bulkhead part number, sounds like daz might have some nip, but we're not sure which part number corresponds to my car.

ZD-300 front bulkhead with cap ?

I'm not sure if that's the right part bud. I think that piece is the 1st picture, from what i've found from searching the part number in google. I'm after the part in the second picture. However i am not 100%.

Anyone know how you can get the yellow stained effect off the chassis?

Yeah the ZD-300 is the cap well that's what I was selling it under wether the whole bulkhead comes in the pack in not sure. I'll check if I've got time tomorrow I'm sure I've got a spre but I'll find out

ah that's the one we were talking about via PM a while back :)

Cheers for the help guys!

If Justin can't find you one i'm 99.9% sure i've got a used lower bulkhead here you can have.

What haven't you got :lol:

Cheers Timmy. Out of interest are you still running my old bmax 2, anodised red?

Lots of things, but the list is getting smaller:woot:

I'm not personally but there's a young member at our club, who has learning difficulties but a lot of talent with these toy cars, so I gave it him to run in the Welsh league last year, he loved it, had a good year with it and will be running it again this year. :thumbsup:

Glad to here its still be used!!