Orca vx3 program card cable
 

Bought a mi4cxl and this came included with an orca rx3 motor I think.

Unfortunately the person has of course lost or not sent the cable for the program box.

Does anyone have an idea where I might acquire a cable and what one looks like?
Will any Lead 3 pin to 4 pin do the job?

MB models should have some. It is a three wires receiver plug to a 4 wires plug similar to a sensor cable connector.

Mine came with 1 but it doesn't work so I connect the receiver cable to the box like the older VXX and that works every time

Does that work without using the 4 pin slot?

Sorry only just noticed your reply, the 4 pin slot doesn't work on mine so I just unplugged the receiver wire and put that in the box as you did on the VXX, the 4 pin was to make it easier if it works

And that will keep your settings? I thought they were lost if you unplugged the receiver

No you only lose them if you reset to default, I swap from blinky to boosted quite regularly so my receiver is unplugged each time, it shouldn't need to be but it's the same on my older VXX and Xerun V2.1s so doesn't bother me.