!help!
 

i was running my week old sphere today in my b4, i couldn't here the noise of the fan so i took the body off to find the fan wires pulled out(out of the fan not the sphere), how do i go about putting them back in because i need the fan for my touring car:cry::cry::cry::cry:

any help appreciated

thanks in advance

Brad

the wires have physicaly come out of the fan, or off the Sphere?

out of the fan

you will need a new fan. the wires can't be put back into the fan, sorry.

oh, ok, ill get one ordered
thanks for the quick replies

Brad

I put one back on mine, requires a very small soldering iron tip, a steady hand and to cut a little bit of the fan away ;)

G

same for me
we must be good or tight asses G!!

what bit do you solder it onto?

ok, you can solder, but it is mighty fiddly, and if you can't solder well, then you are going to knacker the fan anyways.

im quite a good solderer i just dont know what way and where to ssolder them on?

Brad

the motor will be the centre portion of the fan, you should be able to trace where the wire goes into.

http://img72.imageshack.us/img72/121...1091632fs6.jpg
http://img72.imageshack.us/img72/p05...jpg/1/w640.png

theres a pic

you will need to pull the round label off the back of the fan, and they should be obvious to you then

i pulled it off and all there was was a littlr hole wite the motor shaft in it:(