Bmax Rear Inner Hinge Pin mounts
 

Hi all,

Just wondering what setups people are using with regard to these, holes high/low on the front and rear mounts for the rear inner hinge pins?

Kit setup is holes high at the front, low at the back, but the Cragg Euro setup is high/high according to the setup sheet at the back of the manual. How have people found this in terms of how changes impact it?

As I'm sure you know it is primarily an anti-squat setting and to a lesser extent a roll-centre setting. More anti-squat will ride the bumps better and make the back end more responsive to power.

I have mine on the kit setting and can't say I have any complaints, haven't got round to testing any other setting though.