![]() |
Kf bulkhead
Got a couple of kf's with striped shock tower fixings on the bulkhead , any cheeky fixes for this or is it new bulkheads .
|
I've seen some with the back of the boss removed with a dremel and a nut fitted behind the plastic instead.
Not sure if it would be as strong but it might be an option... Wingers |
Pilot drill, 2.5mm, though the hole and out other side at the same angle as the hole in the bulkhead. Then screw in a M3 20-25mm set screw until there is only 10mm sticking out the front. Push the tower and shock guard on, and secure with a couple of washers and nyloc nuts.
|
Quote:
|
If you cant get set screws and you have a dremel,use a cap head bolt
put a nut on first so it cleans the threads after..then.cut the head off the bolt,i used some red threadlock so the stud doesn't undo itself when you undo the nut..works a treat :) |
Quote:
http://www.oople.com/forums/showthread.php?t=146964 |
Cheers guys , like it .
|
All times are GMT. The time now is 05:38 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com