RC10 Graphite
 

the rebuild of my Graphite is coming along , it's not 100% as original as I will be using modern electronics and have used a couple of bits off other cars I have lying around.
I have an old type slipper and wondered if people recommend using a more modern http://i1285.photobucket.com/albums/...psibpbxxbh.jpg type

Can't you put a B4 shaft in it or something and use a new slipper? Or am I going mad and heard something totally different :confused:

yes that is what i'm thinking of doing, just wondered if that was the norm or people carried on with the old type slipper

You will not be able to fit a B4 layshaft in a original Stealth box I believe.

The B4 Layshaft is what early RE-RE worlds kits needed as the shaft was machined too short allowing the back slipper plate to hit the motor plate.The B4 shaft was machined in a different place allowing clearance of the slipper plate. Now included in second batch RE-REs

The Worlds RE-RE idler is I believe a different size including different size bearings.

Part number WORLDS RE-RE IDLER GEAR= 6569

Part number ORIGINAL STEALTH IDLER=6570

I maybe wrong but contact CML to clarify the above, but I think Im right.

The single slipper will more than handle 10.5-9.5 I would not go much below this. I know people running 10 double brushed with lipo with single slipper pad and it handles it no problem.

Hope this helps..............:thumbsup::thumbsup:

Thanks for the good info,10.5 planned so will continue with old slipper

:thumbsup: That will be ok matey......:thumbsup:

ready to roll 10.5 brushless and lipo

http://i1285.photobucket.com/albums/...psoj0ygxl9.jpg
http://i1285.photobucket.com/albums/...pszwqcijly.jpg

Oooooh YES !!!!!

AWESOME JOB...........:thumbsup: