zx 5 rtr, what to upgrade???
 

i have just purchased a zx 5 rtr and am intending to race at my local track, i am a newbie to rc racing and in need of some advice,
as i am probably going to stuff it sooner or later ( probably sooner) i would like to be prepaired, which parts of the rtr would you guys recommend to upgrade for strength and/or performance???
cheers guys, mike

ZX5
 

FRONT BULKHEAD,FRONT UPRIGHT,FRONT AND REAR SUSPENSION ARM SUPPORTS AND A ONE WAY.

I would say if you are leaving the stock motor in then nothing. Things that may break and are worth having a spare of are

LA216
LA210
LA219-7

These are the only parts i have broken on my RTR, recommend some new tyres with foam inserts too as the RTR ones are poor.

Can recommend Jez on here for ZX5 spares, been very good to me.

If you are going to put a hotter motor/esc in it then i would also recommend the following as the plastic parts will fail quite quickly

2 x Steel diff halves LA201 (for front & back) about £10 per set
1 x Universal front driveshafts - 68mm LA231 about £30
1 x Rear wheel axles LA233 about £6.00
1 x Dogbone rear driveshafts LA234 abiut £6.00

You can see what all the part numbers are by using the manual

Hope it helps, had a fast learning curve when i got my RTR :lol:

have a look in the Kyosho section in here, there are a few threads of a similar question. Also look at the main ZX5 upgrade threads as a lot of that will apply to the RTR also.

But steel diff halves and front UJ's would be a good start as said, and what ever the tyres of choice are at your local club.
Some spare diff gears are always worth having as they can strip easily if not shimmed correctly, again tip son that in the kyosho section.

bits
 

got plenty loose bit,new and used.all below rrp.ya jez

steel
 

Yes Steel diff halfs and Drive shafts. ! and if you can push it alloy whisbone hangers !