Upgrade gtb slipper pads and lay shaft
 

Really dumb question but how do I fit this upgrade?! I've worked out that I don't need the left hand side pulley insert as its built into shaft but how do I fit the drive pin as the pulley covers the hole!
I'm running the alloy pulleys by the way.

You need to fit the pins mate both side.thay will fit just need to grind a couple mm off each pin

Hi Chris

As said you do need to put the pin in first, if you are running the alloy pulley you need to just take a tiny bit off the end of the pin, about 0.25mm is all it needs

Thanks guys, I thought it was a bit tight!

You can push it through the plastic pulley, only needs a tickle on the pin if you are using aluminium

yes using the alloy pulleys so I taken a tiny bit off each end.
Cheers again