Wiring KO PS1001 Servo
 

I have a KO servo which has the separate power supply lead and in the old days we used to wire this direct to a tail coming of the esc.

Can anyone tell me where I can wire this too, on a modern brushless setup?

Just connect it to the +ve battery terminal.

G

^^^What he said^^^:thumbsup:

Just make sure you solder in an in-line choke to stop any glitching (although now less critical with brushless motors)

Thanks guys:) thought that would be the case, just wanted to play safe. Think I've still got some chokes.

i am still using a couple of 1001's, they have been fine with lipo. as said above, wire straight to live through a choke. with a ko ps87 i also run a 0.1 ohm resistor before the choke just to make sure currents dont go too high for the old fets.