![]() |
Problem with alloy rear hub
Anyone that has the blue version (not the old one) of the alloy rear hub noticed some play/slack in the left hub? I have 2 sets of them and both have the same problem.
When you put the wheel on and tighten it down, there is still some play toward the outside, about 1 a 2 mm... Wondering if the newest version (black) still has the same problem and if there is a quickfix? |
I don't have that particular problem. But try to add a shim?:thumbsup:
|
I have some play in de right hub, but its only .5 mm. Havent tried shimming it.
|
Quote:
|
Thanks for the reply's! I checked the bearings tonight but they are okay. It looks like the crushtube is just a bit to wide... Will sand it tomorrow!
|
I use the blue Alu hubs and yes my left, the bearing comes out a bit. The right bearing is in tightly. I remember when I first put in the bearings, not sure if both but one at least was a pain to put in, had to apply some grease and even then it was a tight fit.
I just gave my bmax4 a run in the street and it tracks straight at half throttle, at full starts to pull ever so slightly but my street has camber. |
All times are GMT. The time now is 06:40 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com