oOple.com Forums

oOple.com Forums (http://www.oople.com/forums/index.php)
-   Electrics (http://www.oople.com/forums/forumdisplay.php?f=26)
-   -   Problems setting throttle on esc with new receiver (http://www.oople.com/forums/showthread.php?t=152407)

StuartH 12-06-2014 04:29 PM

Problems setting throttle on esc with new receiver
 
Hi, I am trying to set up my esc on my dex210 rtr.

The esc and motor is a speed passion revention combo. I have managed to bind the RTR receiver ok and set up the throttle settings using the bundled radio gear. All ok.

The problem comes when I put in a core rc fhss receiver (because I want to run all cars from my one transmitter). The receiver is bound and steering response is great, however when I am trying to set the throttle points on the esc I am getting no response.

I have tried reversing the setting on the transmitter, switched off all the EPA and trims but I am getting no response at all. Battery is fine and esc seems to work with the other setup.

Any ideas????????

Jleath2834 12-06-2014 05:18 PM

Try disconnecting a motor connection? Worked for me.

StuartH 12-06-2014 05:31 PM

??? bit confused, how would that work? I know you have to disconnect a motor wire to bind the receiver....but to set the throttle you have to put back all the motor plugs even on the rtr setup.

Just can't fathom if it's a receiver issue or not

Jleath2834 12-06-2014 05:40 PM

I had a similar problem. Not sure how or why but found by disconnecting a motor connection then reconnecting the ESC binded without any problems.

StuartH 13-06-2014 09:09 AM

Well blow me, your solution worked! Gave it a shot this morning and all works fine!


All times are GMT. The time now is 04:49 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com