speed passion esc stop working
 

Have just change resoldered my wires on esc now esc has stopped working any ideas why.

Dry joint?
Some solder bridging across between two terminals?

Too much heat frying the board?

As above, maybe first try getting some solder remover and cleaning it right back and starting over.

did you remove ESC from car to replace wires ?

is it possible you have plugged RX lead back in wrong way round either in speedo end or rx end (i know i have )when refitting to car

as above too much heat or bridging terminals may cause same issue

hope it helps

Fid

Thanks for all the advice had speedo checked out and i have fried it.

Sorry to hear that. I currently have one being looked at and I suspect the same. Was working ok then suddenly started spewing smoke