22-4 belts
 

Has anyone tried a 5.5 turn motor in the 22-4? would like to get some feed back on this before i put my 5.5 in and destroy the belts. :confused:

cheers.

iv got a 4.5 Orion 2008 motor in which being a bit of an older spec is around a 5t. Belts are holding up well and iv done a good 4 or so meetings now running it extreamly aggressive on the low end. You will be fine. There's a guy that runs a new spec trinity 4.5 and he seems ok, did do one front belt after clipping a barrier on full power.

Make sure (and keep checking) the clicker is tight. If that backs off at all with that torque it may strip the teeth.