where to connect fan?
 

My ezrun 60a esc fan stopped working so I put a new one in and that doesn't work so tried another 3 new ones and all don't work so I'm guessing the esc fan connector is bust on the esc side,

The fans are only 5v and I run 7.2v 2s cells, they read 8.4v when fully charged obviously.
Where is the best place to get power from for my fan.
Thanks for any replies.

ezrun rans
 

Hi there,this happened to me and all i do is connect mine to the reciever using a old servo wire if you have any spare channels in your receiver as it runs at 6v.Turns on with the car at the esc switch.Hope this helps..jon

Yup, just plug it into the rx.
That's where my early ones went, before I got an esc with built in power.

If you haven't got a spare channel, just get a servo y lead and piggy back it off something like your pt.

Thanks for the answers guys, spare rx plug it is, Thankyou