Advice needed on frsky receiver setup
 

Hi. As title really. Ive just ordered a hack module and a D4R-II receiver. However looking at the pictures, the pin layout is different to how a standard receiver would look. So my question is, does a standard servo plug just push onto the pins (receiver pins look too wide) or do I need special plugs to wire onto my servos?? Sorry if this seems a daft question, ive never actually seen one in the flesh, so can only go off the pictures! Lol
Thanks in advance.
Darren

Yeah regular servo plugs just push on to the pins. signal wire to outside, -ve to centre. The label shows you.

Nice one. Thanks for your reply. Was beginning to worry, the pics of it make it look like the gap between the pins is massive!!!! Lol