b44 cvd's
 

hi there i have a b44 the steel cvds have rusted pretty bad. is there any way of stopping this? or can i replace them with shiny ones if so which ones ? cheers

Just soak them in some wd40.

A

That wont stop the rust ash :lol:

All you can do mate is when its been wet give it a good clean and brush off and then a blast with WD or similar but the ket is to stop it from getting damp :thumbsup:

is there none that you can get that wont rust?

No but it gets rid of it when they do rust.

A

Are you sure it just makes the rust disappear? :confused:

hey...
dose any one know where I can find shiny CVD's ???
MIP don't do them for the b44 :cry:
Has any one tryed fitting the B4 CVDs ??

We talked about this in a thread only some days ago.

http://www.oople.com/forums/showthread.php?t=15157

Thats about the wishbones not the drive shafts

CVD's
 

Hey,

Don't think the B4 and B44 CVD's are the same. They have different part numbers:

AS9599: B4 CVD's

AS9754: B44 Rear CVD's

AS9749: B44 Front CVD's

Anybody know where you can get hold of a set of Lunsford ti turnbuckels and hinge pins?

Andy

dms-racing should have the lunsford turnbuckles its the b4 6 piece set that you want I think

JConcepts do shiny CVD's for the BJ4 which will be a direct fit for the B44 :)

Are you sure on that rich? Or do you mean the whole cvd assembly?

The whole driveshaft Ben :)

only problem is if you have to use the stub axles from the jc cvds which i have seen a staggering amount of them snap and arn't cheap! :thumbdown: i know 2 people on this thread have broken plenty ;):woot:

Must of just had a few bad batches :woot:

I think though 99% of the breakages though have been Ben's :woot:

Do i get a prize for breaking the most :confused: 8!!:woot: ANIMAL!!!!

Manimal!

How many cat diff outdrives have you done now Ben, have you got into double figures yet?!