![]() |
Manual needed for FAB U4133
I don't suppose anyone knows where I can get the manual for the above?
|
This would be a great help because I'm building my K1 next week!
|
FAB U4133
1 Attachment(s)
Hi.
I have the FAB im my K1. it's really nice to have. as for the Manual i cant find any on the net, so here is the one i have at home, hope you can use it, and sorry for the bad quality, my scanner is not the best :) Greetings from Denmark Kent H. |
What are people thoughts on the FAB and what kind of surfaces are people using them on?
|
Quote:
|
Glad you've got sorted Lee. Your stuff has also been sent today ;)
|
Thanks Steve.
I had a problem at the weekend with the FAB. The small pin through the shaft (on the FAB adjust side) came half way out. On spinning round it shaved a groove clean through the Alloy Laymount (part number U4204). I could see no way of tightening this pin other than tap it back into the shaft. I ran the car for one more round and the pin has not moved but surely if it came loose before it will do it again. Has anyone had this happen? |
FAB fix iz..
1 Attachment(s)
hey Dodgy Guy.
first of all im sorry i did not mention this before! Yes idd i have hat the same issue whit the FAB, it did the same damage to my K1 as to yous. I did a small fix to it, and after i never have hat any problems. It is a small ring i squeezed over the small pin so it cant move. hope the image can help you and others. Kent H Denmark |
Quote:
Good idea - I will look around and see if I can come up with something similar. |
The inner ring of a diff bearing is exaxtly what you need.
You may need to grind the aluminum part just a tiny bit. Cruise |
All times are GMT. The time now is 07:36 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com