Associated Hex Rear Wheels on BMax2 MR
 

What are peoples experiences with using Associated rear wheels on the BMAX2?

I assume that if the Associated hexs' are used then some shims will be required to stop the movement of the driveshaft in the hub?

Thank you
Neil

There are several possibilities, I am using BM-011S wheel spacers and proline B4 rear hexes. SC10 adapters are also supposed to work, but I didn't try it so far.

Thanks. Are the proline adaptors these:

http://prolineracing.com/performance...-hex-adapters/

?

If so, I wonder if they are the same thickness as the Associated ones?

Yes, these are the ones. Thickness should be the same.

OK, thanks. I just tried the Associated wheel spacers off my B4, they fit most of the way onto the shaft but fail to go the last ~3mm as the shaft increases in diameter by a very very small amount. I will get the spacers you suggest (off the BMAX4 ?) and give them a try with my Associated wheel hex adapters.

The car is now all ready to go, I just need my new shell.

Neil

I am using b4 front hexes over the stock conical spacer. It's really easy and the offset is the same.