Wheel fitments on MR2
 

Hi
Can the dex210 wheels fit the yoko?
I can see that the rear hex could work but what about the fronts?
Thanks

If you know the size of the bearing I can tell you tonight :thumbsup:

On the MR2, both Yokomo and Associated (with other front wheel axles: B2-010FI) wheels work.

Seems like thy use 5x10x4 same as the dex.
Ill get back to you about the offset both front and rear

DEX210 fronts fit straight on and go inside the BRCA box easily. I use them as they are a better fit when running low profile staggers and a trimmed down rim.

Rears will only fit if you use the AE hext conversion kit.

Dex210 rears will fit on mr2 with these kit? Really? Do you have a part number for it?
Tia

I run Durango all round on my Bmax2 MR :)

Doesn't the alu TD hex fit on the shaft? or even the tresrey locking one?

How do you set up the rear hexes mate? Can we see a pictures please? :thumbsup:

Aren't the offsets different?

HB 12mm hex
 

The HB 12mm black alloy hex fits straight onto the rear axle with no modification. I use AKA rims which have minimal, if any offset difference when mounted.
Cheers All

The Tresrey would fit but it would widen the track too much I reckon as they sit on the other side of the pin (as i'm sure you know :) )

Have been running Durango rims since I built the car, see info here:

http://www.oople.com/forums/showthread.php?t=125033

Thanks RichyUK :D

I tried the TD fronts just quickly and it seem like the plastic in between the bearings is too wide, it locks the wheel when tightened.

Are you shimming the screw or anything?

Ill try again later when I have more time

The rears fit with the plastic hexes and shims, Ill have to measure track width against the 210 so its legal.

Ahh I have the alu hubs and my hex was on the outside, that may be the problem I have there.

I run kit and Schumacher wheels on the rear and kit only on the front