Fitting a Savox 1251 in a 210
 

Hi

Just got a low profile 1251 for my 210, but I can't get it to fit due to where the wires come out of the casing.
Am I doing something wrong or do I need a different servo?

Thanks

More jiggling needed, all servos are a bit tight due to the shape of the chassis side rails.

If you are worried about bending the servo wire, try relieving the rail there, 2 minutes with a dremel should do it......

You should use a servo saver with the 1251 servo or you will need to replace gears often..

Thanks for the advice guys.

Hope you have no Tekin ESC, is not working with Savox

You might also need a glichbuster capacitor as well because savox servos can draw to much current from your ESC