K1 not fitting in BRCA Box
 

hi ive just fitted the 10 degree alloy pivot blocks on my k1 with 2m of track washers front and back, ive just tried to put it in a box 250mm wide and the nuts seem to be catching on the side of the box it will go in with excessive force but then i cant pull it out im just wondering if i have done anything wrong.

thanks in advance

heres a pic

http://i1313.photobucket.com/albums/...ps0edf846c.jpg

kit is only 1mm front track washers and as far as im aware thats what the team run.
simple answer if its too wide take some washers out!

hmm i wonder how mossy is fitting his in the box as im going off his setup and apparently hes ran 2m track:confused:

Simon's setup uses 1mm track width spacers at the front.

http://www.petitrc.com/setup/schumac...SetupSheet.pdf

:S have i miss read this or am i right haha:p

1) The setup sheet you're copying wasn't a BRCA event
2) His latest setups use 1mm

ahh ok

thanks :)

I have 2mm washers on the front of mine with alloy blocks and it fits fine. Ran it at last regional.

2mm on the front of a K1 will be very wide. It was fairly wide on the SX series, and the K1 bulkheads are wider.