B44.1 or .2 used at kiddy
 

Reports show .1 was used was that correct ? Or just a typo?

That's an oOple oOps, all the 44's in the A were .2's :)

Ahh good. Cud you pm or post set up rich? Please

and me please

Be interesting to find out which pistons you finished with in the end after RHR!
I've not tried the 3 hole ones yet!!
Gaz

Bradder's setup is online with CML (http://www.cmldistribution.co.uk/pro...r-Bradders.pdf).

This is pretty close to where I ended up, with the main differences being was I ran one spring stiffer on the front and 2.5wt heavier on oil all round.

Bradders set up
 

This set up is blank :(

Are you by any chance accessing this from an iPhone/iPad? if so, then download the Acrobat Reader app and then open the PDF in this app. This should sort the issue.

Thanks for the link and oil update Phil.

I struggled fro grip on Sunday and took my roll bars off- I had a lot of push in the final left turn by the wall into the short right that turned into sweeper around the straigh- Should I have kept the rear roll bar on? When it was dry for round 3 i ran both roll bars 9(as I had up until round 4)and didnt have this issue

Would you guys always run this set up in the Wet?

In the wet always as a rule remove front bar and rear or run a black thin rear.
If you hadn't softened the front end or changing to a shorter link then the front end would push on slightly more as you've noted.

Gaz