Sanwa M12 Binding Problems :(
 

Hi guys/gals

I have probably the same problem everyone else has on here. The story begins like this,

I purchased and received on Friday my spanking new Sanwa M12 and RX-462 I was ecstatic. I had them paired on the Friday night and was tinkering happily. I turned it off and went to bed. in the morning i tried to re bind after a couple of alterations but all the receiver does is flash for 10 seconds slowly and doesn't seem to be receiving a signal from the transmitter. I have cleared the models saved just encase and reverted anything back to standard I can think of, with no luck. I do believe there is no way of resetting either component. If this isn't true please say I'm in need of serious help mentally and physically :(

If anyone has any suggestions please say I'm desperate?!?!

Thanks all

Sam

Did you ever sort this out? Having same problem:cry:

Really interesting as I have a similar prob as well

presume it is nothing obvious like the different setting modes for compatibility?

See the link below
http://www.lrp.cc/fileadmin/Download...ode_MT4_en.pdf

Nope as I switched to an already binded one and that didn't work