![]() |
First circuit this weekend with my Supastox - setup advice
Gents
First circuit run this weekend at the local club, any setup advice for my supastox you can pass on ? Kit out of the box built at the moment, springs, o-rings the lot. Thanks for any info :thumbsup: |
You'll be fine with it straight from the box, its surprisingly good in that set up.
|
The only thing I did on my sons car when I built it was put the rear springs on the outer hole and put some larger washers under the rear pod between o rings and pod as the standard ones tend to work themselves through the hole and hold the rear pod at funny angle making the car corner good one way and bad the other and that was about it and put the stickers on tyres as it helps to stop them getting chunked
|
Run kit settings, run as low as possible. If you got the diff, strip, degrease, relube, adjust as tighten fully, back off one whole turn and then a 1/16th.
|
relace the o rings on the rear pod with these, fitting washers will reduce your droop.
http://www.maplin.co.uk/silicon-washers-99272 |
Take one of the rake spacers (is that what theyre called?) out.
|
Quote:
|
Quote:
Would surely appreciate something that can protect my tires a bit longer. |
Quote:
|
larger stickers?? Never noticed those :wtf::rolleyes:
|
Quote:
|
SupaStox Setups tips
Have a look at this download - from Facebook GT12 Circuit Cars (UK) some good Supastox setup tips
https://www.facebook.com/groups/3364...5417218858027/ |
All times are GMT. The time now is 02:25 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
oOple.com