help needed !!!!!please!!!!!
 

My slipper in my S4 keeps on comeing loose but i have no instructions on how to rebuild the slipper ???

or is it because the plates and pads are worn ????


thanks for the advise in advanse:thumbsup:

http://www.oople.com/forums/showthread.php?t=4149
read richard lowes advice problem solved

where can i get a compleate new slipper from

also do anyone have part numbers

thanks :)

theres a bloke on ebay selling a bj4 broken for spares hes across the pond but hey its cheaper than a new one

I need it for the weekend.....????

mk racing?

Does it have the Atomic Carbon slipper mod? if no, contact Jonathan asap that is the best investment for this car ...

no it doesn't

what is included in the AC slipper mod.....

good point

yeh id like to know aswell please :thumbsup:

is there anywhere i can get a new slipper srew, nut,spring and spacer from in the UK

:)

yes snap :thumbsup:

That is a new T nut in mteal with a grubscrew to hold the long slipper screw in place..you thread it in on the one side, then ya using the grubscrew to threead it in the T-Nut, that will make it not loosen up...after ya adjust it, then just use loctite and ya done..

Jonathan is on his way back from Belgium. Drop him an e-mail and he'll sort you out.

you could try using a nylock and a std nut and tighten the two against each other gently to stop them moving

MK racing carries a lot of J concepts parts. If you get them by Friday bring them to club and I'll build the slipper up for you :)

Are they all listed on there website as i cant find them on there :)

also have anyone got the part numbers for srew set, plates and pads :)