tc02c polished floor setup?
 

Does anyone have a base setup for a polished floor? Also what weights are you running?

Used mini mini pin rear and used stigger front.
30 Grs front brass + 20 to 40 Grs near the servo.
Rear + 15/20 Grs near the pack and 20/30 opposite the motor to have a good lalance Right and left.
If you used saddle not to heavy putt 30 or 40 Grs more.
+2Mm on the dumper down the piston.
I will use the alu + 3.5° with rear hub +1°

For the other part I've a quite good steup, but it's too big to post him on the forum so give me your Email.